My plan has always been to use LED lighting above the entire running surface of the layout. This has been achieved with low cost products available on-line or locally.
The first step was to build a lighting pelmet above the layout with the front surface directly above the fascia board around the layout. This was attached to the walls (or window and door architraves) as shown below:
The complete surface which will be facing the walls has been painted gloss white for maximum light reflection. Back to the preliminary fitting:
This is the only corner which requires fitting to a wall. To facilitate this I have attached a mounting plate to the wall spanning a bit more than the distance between two (steel) studs. The right angle joins have been made using pieces of slotted gal. angle from Bunnings (Metal Mate Galvanised Heavy Duty Slotted Steel Angle 38mm x 38mm x 1.8mm angle x 900 long …$11 AU June 2018)
I used timber (hoop pine) which I had on hand to a finished size of 170 x 17mm but those dimensions aren’t critical.
The LED self adhesive LED strips were obtained on-line from Oatley Electronics at Ettalong Beach : Check the Website
I purchased 4 x (SB-5m long 24V -NW-PW) Pure white LED Strips at a total cost of $36 inc GST [so a 5m strip costs $9 excluding postage]
If you want to see the pics full size – Right Click on it & select “View Image”
OR Double Tap on an iDevice
For testing purposes I also bought a KC24 24V/1Amp power supply but it was not up to the task when I tried it on a 4m length of LEDs. The non ventilated plastic pack couldn’t handle the load and overheated as expected. This is explained fully in the PDF Oatley makes available on their website: PDF
Some of the strips they supply are 12v but they would not have been bright enough for my
The end result below is the effect I am after with most of the light restricted to the layout only. There is a problem visible here …
I suppose the question is DOES IT WORK?
What I was trying to achieve was something like a continuous “stage” effect. I think the pelmet should be painted Brunswick green, the same as the fascia. Here is trial run with Photoshop to see what it might look like then.
As is: “A”
How I think it should be:(it’s a shame I took both pics with the main overhead room light on. What do you think????
There may be a bit more as I finish it off … Rick